Page 1
AIR PURIFIER OPERATION MANUAL “Plasmacluster” and “Device of a cluster of grapes” are trademarks of Sharp Corporation. *The number in this technology mark indicates an approximate number of ions supplied into air of 1 cm which is measured around the center of a room with the “high-density plasmacluster 7000”...
Page 14
Please read before operating your new Air Purifier The air purifier draws in room air from the air intake, passes the air through a pre- Filter, a HEPA Filter inside of the unit, then discharges the air through the air outlet. The HEPA Filter can remove 99.97% of dust particles as small as 0.3 microns that pass through the filter.
Page 15
*When air is drawn through the filter system. Thank you for purchasing the SHARP Air Purifier. Please read this manual carefully. Before using this product, be sure to read the section: “Important Safety Instructions.”...
• Be cautious when cleaning the unit. Corrosive cleansers may damage the exterior. • Only a Sharp Authorized Service Center should service this air purifier. Contact the nearest Service Center for any problems, adjustments, or repairs.
Page 17
CAUTIONS CONCERNING OPERATION • Do not block the intake and/or air outlet. • Do not use the unit near or on hot objects, such as stoves or heaters or where it may come into contact with steam. • Do not lay the unit down when using. •...
PART NAMES FRONT BACK MODE Button, indicator light(green) Main Unit (Press 3 sec.) Plasmacluster Ion ON/OFF Button Air Outlet HEPA Filter OFF TIMER Button,Indicator Light(green) (Press 3 sec.) Filter Reset Button Back Panel (Pre-Filter) Replace Filter indicator Light(orange) Bottom Tabs Plasmacluster Ion Indicator Light (blue) Handle POWER ON/OFF Button...
FILTER INSTALLATION Be sure to remove the power plug from the wall outlet. To maintain the quality of the fi lter, it is installed in the main unit and packed in plastic bag. Be sure to remove the fi lter from the plastic bag before using the unit. Remove the Back Panel.
OPERATION CLEAN AIR START STOP • Select the desired fan speed. • Unless the power cord has been unplugged, the operation starts in the previous mode it was operated in. CLEAN ION SHOWER Releases high-density Plasmacluster ions and discharges strong air flow for 60 minutes. START NOTE •...
Page 21
OFF TIMER Select the time turning off the unit during operation. The unit automatically stops once the selected time is reached. ● ● CANCEL Light Control You can set the Plasmacluster Ion Indicator to OFF when the Plasmacluster Ion Indicator is bright. NOTE •...
CARE AND MAINTENANCE To maintain optimum performance of this air purifier, please clean the unit including the filter periodically. Be sure to disconnect the power cord from the wall outlet before performing any maintenance. Back Panel (Pre-filter) Gently remove dust from the Back Panel by using a vacuum cleaner attachment or similar tool.
REPLACEMENT GUIDELINES HEPA Filter Replacement timing When Replace Filter Indicator light turn on Model : FZ-F30HFE Replace the Filter according to the instructions provided with the replacement filter. After the exchange, insert the plug in socket and press the POWER button, and OFF TIMER button 3 seconds.
TROUBLESHOOTING Before calling for repair, please review the list below, since the problem may not be a unit malfunction . SYMPTOM REMEDY (not a malfunction) Dust and smoke are not removed. • Clean or replace the filter if they appear to be heavily soiled.
Need help?
Do you have a question about the FP-J30TA and is the answer not in the manual?
Questions and answers