Page 1
AIR PURIFIER OPERATION MANUAL “Plasmacluster” and “Device of a cluster of grapes” are trademarks of Sharp Corporation. *The number in this technology mark indicates an approximate number of ions supplied into air of 1 cm which is measured around the center of a room with the “high-density plasmacluster 7000”...
Page 2
Please read before operating your new Air Purifier The air purifier draws in room air from the air intake, passes the air through a pre- Filter, a HEPA Filter inside of the unit, then discharges the air through the air outlet. The HEPA Filter can remove 99.97% of dust particles as small as 0.3 microns that pass through the filter.
*When air is drawn through the filter system. Thank you for purchasing the SHARP Air Purifier. Please read this manual carefully. Before using this product, be sure to read the section: “Important Safety Instructions.”...
• Be cautious when cleaning the unit. Corrosive cleansers may damage the exterior. • Only a Sharp Authorized Service Center should service this air purifier. Contact the nearest Service Center for any problems, adjustments, or repairs.
Page 5
CAUTIONS CONCERNING OPERATION • Do not block the intake and/or air outlet. • Do not use the unit near or on hot objects, such as stoves or heaters or where it may come into contact with steam. • Do not lay the unit down when using. •...
PART NAMES FRONT BACK MODE Button, indicator light(green) Main Unit (Press 3 sec.) Plasmacluster Ion ON/OFF Button Air Outlet HEPA Filter OFF TIMER Button,Indicator Light(green) (Press 3 sec.) Filter Reset Button Deodorizing Filter Replace Filter indicator Light(orange) Back Panel (Pre-Filter) Plasmacluster Ion Indicator Light (blue) Bottom Tabs POWER ON/OFF Button...
FILTER INSTALLATION Be sure to remove the power plug from the wall outlet. To maintain the quality of the fi lter, it is installed in the main unit and packed in plastic bag. Be sure to remove the fi lter from the plastic bag before using the unit. Remove the Back Panel.
OPERATION CLEAN AIR START STOP • Select the desired fan speed. • Unless the power cord has been unplugged, the operation starts in the previous mode it was operated in. ALLERGY The unit operates at MAX fan speed for 51 minutes. START NOTE •...
Page 9
OFF TIMER Select the time turning off the unit during operation. The unit automatically stops once the selected time is reached. ● ● CANCEL Light Control You can set the Plasmacluster Ion Indicator to OFF when the Plasmacluster Ion Indicator is bright. NOTE •...
CARE AND MAINTENANCE To maintain optimum performance of this air purifi er, please clean the unit including the fi lter periodically. Be sure to disconnect the power cord from the wall outlet before performing any maintenance. Back Panel (Pre-fi lter) Gently remove dust from the Back Panel by using a vacuum cleaner attachment or similar tool.
REPLACEMENT GUIDELINES Filter Replacement timing When Replace Filter Indicator light turn on HEPA Filter Model : FZ-F30HFE HEPA Filter Model : FZ-F30DFE Deodorizing Filter Deodorizing Replace the Filter according to the instructions Filter provided with the replacement filter. After the exchange, insert the plug in socket and press the POWER button, and OFF TIMER button 3 seconds.
TROUBLESHOOTING Before calling for repair, please review the list below, since the problem may not be a unit malfunction . SYMPTOM REMEDY (not a malfunction) Dust and smoke are not removed. • Clean or replace the filter if they appear to be heavily soiled.