Chapter 4 Printer Connection And Software Installation; Overview Of Network Setup And Configuration (Epson Aculaser Cx17Nf/Cx17Wf Only) - Epson AcuLaser CX17 Series User Manual

Chapter 4
Printer Connection and Software Installation
Overview of Network Setup and Configuration (Epson AcuLaser CX17NF/
CX17WF Only)
To set up and configure the network:
1. Connect the printer to the network using the recommended hardware and cables.
2. Turn on the printer and the computer.
3. Print the System Settings page and keep it for referencing network settings.
4. Install the driver software on the computer from the Software Disc. For information on driver
installation, see the section in this chapter for the specific operating system you are using.
5. Configure the printer's TCP/IP address, which is required to identify the printer on the network.
❏ Microsoft
®
automatically set the printer's Internet Protocol (IP) address if you connect the printer to an
established TCP/IP network. You can also manually set the printer's IP address on the
operator panel.
❏ Mac OS
®
X systems: Manually set the printer's TCP/IP address on the operator panel. To use a
wireless connection, also configure wireless settings on the operator panel. (A wireless
connection is available only on the Epson AcuLaser CX17WF.)
6. Print a System Settings page to verify the new settings.
Note:
The reports and lists are all printed in English.
See Also:
"Printing a System Settings Page" on page 149
®
Windows operating systems: Run the Installer on the Software Disc to
Epson AcuLaser CX17 Series
Printer Connection and Software Installation
User's Guide
41