Configure Primary Port Command - NorthStar 2505 Installation Manual

Configure primary port
command
2505 INSTALLATION MANUAL, Revision A
This message is used to change the primary port mode. Once
this command is issued to the GPS receiver, the controller
supporting the Monitor mode protocol is activated, then NMEA
communications with the GPS receiver can be restored only by
using binary message #110. On power-up, with NVM, the
primary port stays in the same mode. Without NVM, the
default mode is Monitor Mode (CMC Binary).
HEADER
$PMCAG,000,x*hh<CR><LF>
Character
Example:
Configure the Primary Port to Monitor Mode at 19200.
$PMCAG,000,0*58<CR><LF>
Appendix C NMEA output protocol
CONTENTS OF DATA FIELDS
baud rate selection1
Baud rate
0 19200
1 300
2 600
3 1200
4 2400
5 4800
6 9600
7 19200
8 38400
Page 27