Hitachi Gigabit Router GR2000-B Series Installation Guide
Step 4.
To install another DIMM, line up the notches in the DIMM with the mating
keys in the slot. Making sure that the lever on the memory slot is open,
carefully guide the DIMM into the slot shown in Figure 5-18 below. Seat the
DIMM into the slot snugly. You will know when the DIMM is properly
seated, as the lever will snap into the closed position.
Lever
Figure 5-18 Removing the Memory Module
Step 5.
Reversing the procedure in Figure 5-16, re-install the cover, making sure
that you don't pinch any wire or cables.
Caution:
!
Step 6.
Using a Phillips screwdriver, install the two screws at the rear of the chassis
as shown in Figure 5-15.
5-16
(C)
Memory Slot
When you place the cover on the router, make sure that no wires or cables
are pinched.
GR2K-GA-0007
Rev. 5.00