DeWalt DXAELJ16CA Instruction Manual page 14

7. When the process is completed, disconnect the jump-starter.
First remove the negative BLACK (–) clamp from vehicle
chassis, and then remove the positive RED (+) clamp from
the positive battery post. Disconnect the double barrel Smart
Cables Connector from the Smart Cables Port.
8. Store the Smart Cables Controller in a safe place.
9. Recharge the unit fully.
IMPORTANT NOTES:
If the battery clamps are incorrectly connected with regard to polarity,
the Bi-Color LED Status Indictor will light red until the clamps are
disconnected. Remove the clamps and then reconnect them with
correct polarity.
If the voltage of the unit's internal lithium battery is low and has
insufficient output power, the Bi-Color LED Status Indictor will light
red. Disconnect the unit and fully charge following the directions in
the "Charging / Recharging" section.
If the Smart Cables Controller is overheated, the Bi-Color LED
Status Indictor will light red. Disconnect the Battery Clamps and
allow the unit to cool down for a period before resuming any
operation.
If the cranking current and/or time period exceeds the unit's
parameters, the Bi-Color LED Status Indictor will flash red for
50 seconds (a cooling down period) before lighting green again
(resuming normal operation).
CAUTION – To avoid the risk of property damage:
• If the vehicle doesn't start after the first attempt, allow a resting/
cooling period of 4 to 5 minutes before making asecond attempt.
If a second attempt doesn't start the vehicle, discontinue use
and look for other problems that need to be corrected. The
battery may be damaged.
• NEVER attempt to use the unit to start a vehicle while it is in
charging mode.
• Using the jump-starter without a car battery installed in the
vehicle will damage the vehicle's electrical system.
IMPORTANT: Always turn the unit off when not in use. Recharge this
unit fully after each use.
CAUTION – TO REDUCE THE RISK OF PROPERTY DAMAGE:
• Vehicles that have on-board computerized systems may be damaged
if vehicle battery is jump-started. Before jump-starting this type of
vehicle, read the vehicle manual to confirm that external-starting
assistance is advised.
• Excessive engine cranking can damage the vehicle's starter motor. If
the engine fails to start after the recommended number of attempts,
discontinue jump-start procedure and look for other problems that
need to be corrected.
• If vehicle fails to start, turn off the ignition, disconnect the jump-start
system's leads and contact a qualified technician to investigate why
the engine did not start.
OPERATING THE TYPE C USB PORT, TYPE
A USB PORT, AND LED LIGHT
The Type C Port, Type A USB Port and LED Light are located on
opposite sides of the unit. They are all controlled by the Power
Button (on the front of the unit). Refer to the "Features" section to
locate.
1. Press the Power Button on the unit once. The Type C Port and
USB port are both ready to use.
2. Lift up the protective cover of the Type C and Type A USB
ports. Plug the USB-powered device into the appropriate USB
power port and operate normally.
13