Setting Up Miele@Home; Running The First Wash Programme - Miele WTD 160 Operating Instructions Manual

Before using for the first time

Setting up Miele@home

There are 2 ways of connecting:
1. Via the Miele app (default)
2. Via WPS
Logging in via the Miele app
 Turn the programme selector to the
MobileStart  programme.
 appears on the time display. The
timeout then starts to count down from
10 minutes on the time display.
The Miele app will guide you through
the remaining steps.
When you have successfully connected,
 will appear on the time display.
Logging in via WPS
 Turn the programme selector to the
MobileStart  programme.
 Touch the  sensor control until 
appears on the time display and a
short keypad tone sounds.
The timeout then starts to count down
from 2 minutes on the time display.
When you have successfully connected,
 will appear on the time display.
18
Tip: If the connection has not been set
up when the timeout has finished
counting down, repeat the process.
Running the first wash
programme

Damage resulting from failure to
remove the transit bars.
Failure to remove the transit bars can
result in damage to the washer-dryer
and to adjacent cabinetry or
appliances.
Remove the transit bars as described
in "Installation".
Before first use, the Cottons
programme must be run without
laundry and without detergent.
 Open the stopcock.
 Turn the programme selector to
Cottons.
The washer-dryer is switched on and
the temperature 40 °C lights up in the
control field.
 Touch the Start/Add laundry sensor
control.
The wash programme will start.
After 10 minutes, the indicators dim,
except for the Start/Add laundry
sensor control.