Setting Up Miele@Home; Running The First Wash Programme - Miele WTD 160 Operating Instructions Manual

Before using for the first time

Setting up Miele@home

There are 2 ways of connecting:
1. Via the Miele@mobile app (default)
2. Via WPS
Logging in via the Miele@mobile app
 Turn the programme selector to the
MobileStart  programme.
 appears on the time display. The
timeout then starts to count down from
10 minutes on the time display.
The Miele@mobile app will guide you
through the remaining steps.
When you have successfully connected,
 will appear on the time display.
Logging in via WPS
 Turn the programme selector to the
MobileStart  programme.
 Touch the  sensor control until 
appears on the time display and a
short keypad tone sounds.
The timeout then starts to count down
from 2 minutes on the time display.
When you have successfully connected,
 will appear on the time display.
18
Tip: If the connection has not been set
up when the timeout has finished
counting down, repeat the process.
Running the first wash pro-
gramme

Damage resulting from failure to
remove the transit bars.
Failure to remove the transit bars can
result in damage to the washer-dryer
and to adjacent cabinetry or appli-
ances.
Remove the transit bars as described
in "Installation".
Before first use, the Cottons pro-
gramme must be run without laundry
and without detergent.
 Open the stopcock.
 Turn the programme selector to Cot-
tons.
The washer-dryer is switched on and
the temperature 40 °C lights up in the
control field.
 Touch the Start/Add laundry sensor
control.
The wash programme will start.
After 10 minutes, the indicators dim,
except for the Start/Add laundry
sensor control.