Table of Contents
Advertisement
C. Insert the orifice into the opening of the manifold
block, positioning it so that the chamfered end is
inward
(Figure
D. Thread the solenoid valve into the lift valve
manifold block, and torque the valve to 27 N-m
(20 ft-lb).
Note: Do not overtighten the nut.
E. Insert the coil/spacer assembly onto the solenoid
valve
(Figure
8).
F. Secure the coil/spacer assembly to the valve with
the nut
(Figure
(5 ft-lb).
Note: Do not overtighten the nut.
3. Disconnect the hydraulic hose from the 90 degree
fitting on the front of the lift valve manifold block
(Figure
9).
Note: Have a drain pan or a rag available to catch the
hydraulic fluid.
Figure 9
1. 90 degree fitting
2. Lift valve manifold block
4. Remove the 90 degree fitting from the front of the
manifold block
(Figure
Note: To gain additional access to the fittings on the
front of the valve, disconnect the hard hydraulic line
from the valve and/or remove the valve mounting nuts
(Figure
9).
5. Install the tee fitting into the vacated port on the front
of the manifold block.
Note: Position the tee fitting as shown in
8).
8), and torque the nut to 7 N-m
3. Hydraulic hose
9) and discard the fitting.
Figure
1. Tee fitting
2. Front of manifold block
6. Install the adapter fitting to the newly installed tee
fitting
(Figure
7. Install the end of the hydraulic hose, disconnected in
step 3, to the adapter fitting
g025291
10.
7
Figure 10
3. Hydraulic hose
4. Adapter fitting
10).
(Figure
10).
g025598
Advertisement
Table of Contents
