Table of Contents
Advertisement
Connecting the Long Hose
(2WD Models Only)
This procedure does not apply to 4WD models.
1. Install the end of the long hydraulic hose to the inboard
port of the right wing cylinder and tighten the fitting.
2. Route the hose from the right wing cylinder along the
mid-length hose, under the hydraulic tank bracket,
above the lift shaft, and below the floorboard support
to the capped fitting on the hydraulic hard line
17
and
Figure
18).
Figure 17
1. Capped fitting
Figure 18
Some parts not shown
1. Floorboard support
2. Lift shaft
3. Remove and discard the cap from the fitting
17).
(Figure
g027153
g027154
3. Right wing cylinder hose
4. Hydraulic line fitting
(Figure
4. Connect the right wing cylinder hose to the fitting on
the hydraulic line
Note: Make sure that the hose is not twisted and will
not contact any hot, sharp, or moving parts.
11
(Figure
18) and tighten the fitting.
Advertisement
Table of Contents
