Installing The Adapter Kit; Applying The Decals - Toro 31102 Installation Instructions Manual

C. Slide the driveshaft end yoke from the gearbox
shaft.
D. Raise the driveshaft and tie it to the frame.
7. Slide the deck away from the machine.

Installing the Adapter Kit

Applying the Decals

1. Remove the existing height-of-cut decal from the
height-of-cut bracket on the machine
1. Height-of-cut decal
2. Make sure that the decal mounting surface of the
height-of-cut bracket is free of all grease and grime.
3. Affix the new height-of-cut decal to the bracket
(Figure 5).
(Figure
Figure 4
2. Height-of-cut bracket
4).
1. Lock nut
2. New height-of-cut decal
4. Install the 1/2 x 2-3/4 inch bolt, flat washer, and 1/2
inch flange nut into the lower rear hole of the new
decal as shown in
Note: This keeps the deck from lowering and
contacting the ground if the height-of-cut pin is
removed.
5. Pivot open the floor plate
g025286
1. Belt-routing decal
6. Affix the new belt-routing decal over the existing decal
(Figure
Note: Make sure that the mounting surface is clean
before installing the new decal.
5
Figure 5
3. Bolt
4. Washer
Figure 5.
(Figure
Figure 6
2. Floor plate
6).
g025287
6).
g025288