Table Of Contents - Toro 02720 Operator's Manual

This product complies with all relevant European
directives; for details, please see the separate product
specific Declaration of Conformity (DOC) sheet.
Introduction
This flail-blade cutting unit is mounted to a walk-behind
traction unit and is intended to cut grass and other
low-lying vegetation within the limitations stated in
this manual. Using this product for purposes other
than its intended use could prove dangerous to you
and bystanders.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
Visit www.Toro.com for product safety and operation
training materials, accessory information, help finding
a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
1. Model and serial number location
Model No.
Serial No.
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
© 2022-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
Figure 1
The safety-alert symbol
this manual and on the machine to identify important
safety messages that you must follow to avoid
accidents. This symbol will appear with the word
Danger, Warning, or Caution.
•
Danger indicates an imminently hazardous
situation which, if not avoided, will result in death
or serious injury.
•
Warning indicates a potentially hazardous
situation which, if not avoided, could result in
death or serious injury.
•
Caution indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderate injury.
Contents
Safety ....................................................................... 3
General Safety................................................... 3
Cutting Unit Safety.............................................. 3
Safety and Instructional Decals .......................... 4
Product Overview ..................................................... 5
Specifications .................................................... 5
Attachments/Accessories ................................... 5
Operation .................................................................. 6
Adjusting the Height of Cut ................................. 6
Adjusting the Anti-Scalp Skids ............................ 6
Maintenance ............................................................. 7
Recommended Maintenance Schedule(s) ............. 7
Pre-Maintenance Procedures ................................ 7
Preparing the Machine for Maintenance.............. 7
Lubrication ............................................................ 8
Greasing the Machine......................................... 8
g373546 Drive System Maintenance .................................... 9
Checking the Gearbox Oil Level.......................... 9
Brake Maintenance ............................................. 10
Checking and Adjusting the Brake .................... 10
Belt Maintenance .................................................11
Replacing the Rotor Drive Belt ...........................11
Replacing the Gearbox Drive Belt ..................... 12
Cutting Unit Maintenance ..................................... 13
Inspecting the Blades ....................................... 13
Replacing a Blade ............................................ 13
Cleaning Under the Guards .............................. 13
Checking the Rubber Discharge Guards........... 13
Storage ................................................................... 14
2
(Figure 2) appears both in
Figure 2
Safety-alert symbol
Contact us at www.Toro.com.
Printed in the USA
All Rights Reserved
sa-black