Safety Instructions - Mitsubishi Electric 800 Series Instruction Manual

Safety instructions

Thank you for choosing this Mitsubishi Electric inverter plug-in option.
This Instruction Manual provides handling information and precautions for use of this product. Incorrect handling might cause an unexpected fault. Before
using this product, always read this Instruction Manual carefully to use this product correctly.
Please forward this Instruction Manual to the end user.
Do not attempt to install, operate, maintain or inspect the product until you have read through this Instruction Manual and supplementary
documents carefully and can use the equipment correctly. Do not use this product until you have a full knowledge of this product mechanism,
safety information and instructions. In this Instruction Manual, the safety instruction levels are classified into "WARNING" and "CAUTION".
WARNING
Incorrect handling may cause hazardous conditions, resulting in death or severe injury.
Incorrect handling may cause hazardous conditions, resulting in medium or slight injury, or may cause only material
CAUTION
damage.
CAUTION
The level may even lead to a serious consequence according to conditions. Both instruction levels must be followed
because these are important to personal safety.
 Electric Shock Prevention
WARNING
 While the inverter power is ON, do not open the front cover or the wiring cover. Do not run the inverter with the front cover or the wiring cover
removed. Otherwise you may access the exposed high voltage terminals or the charging part of the circuitry and get an electric shock.
 Do not remove the inverter front cover even if the power supply is disconnected. The only exception for this would be when performing wiring
and periodic inspection. You may accidentally touch the charged inverter circuits and get an electric shock.
 Before wiring or inspection, LED indication of the inverter unit operation panel must be switched OFF. Any person who is involved in wiring or
inspection shall wait for at least 10 minutes after the power supply has been switched OFF and check that there is no residual voltage using
a tester or the like. For some time after the power-OFF, a high voltage remains in the smoothing capacitor, and it is dangerous.
 Any person who is involved in wiring or inspection of this product shall be fully competent to do the work.
 The plug-in option must be installed before wiring. Otherwise you may get an electric shock or be injured.
 Do not touch the plug-in option or handle the cables with wet hands. Otherwise you may get an electric shock.
 Do not subject the cables to scratches, excessive stress, heavy loads or pinching. Otherwise you may get an electric shock.
2