Advertisement
Figure 10
1. Mark on the bolt
27. Secure the sensor wire to the bracket using a cable tie
as shown in
Figure
11.
Figure 11
2. Sensor wires
2
Moving the Proximity
Sensor and Replacing the
Rod-Loading Adjustment
Hardware
Parts needed for this procedure:
2
Bolt (M8-1.25 x 40 mm)
2
Bolt (M8-1.25 x 30 mm)
2
Bolt (M5-0.08 x 25 mm)
2
Nut (M5-0.08 mm)
2
Bolt (M8-1.25 x 20 mm)
Procedure
1. Measure the distance from the proximity sensor to the
extension on the machine as shown in
1. Measure the distance here
2. Move the front cam proximity sensor and bracket from
the front of the machine to the rear cam cylinder on the
rear of the machine as shown in Box A of
6
Figure
Figure 12
Figure
12.
13.
Advertisement
