Advertisement
Figure 32
2. Weld the plate flag to the carriage assembly 5 7/8
inches away from the spindle end of the carriage
assembly as shown in
Figure 33
1. 5 7/8-inch gap
3. Paint the welded area.
4. Disconnect the wiring harness on the existing rear
sensor
(Figure
34) and route the wiring harness through
the holes on the bracket as shown in
Figure
33.
2. Plate flag
Figure
35.
Existing rear sensor
1. Existing sensor
5. Tag the sensor and wiring harness to note which part
of the harness goes to which sensor
6. Disconnect the wiring harness from the 2 proximity
switches
(Figure
1. Pipe-breakout sensor
14
Figure 34
Current routing
Figure 35
(Figure
36).
Figure 36
2. Pipe-return sensor
36).
Advertisement
