Setup; Mounting The Bunker Pump To The Traction Unit - Toro Sand Pro 3040 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
Media and Additional Parts
Description
Parts catalog
Operator's Manual
Certificate of conformity
Note:
Determine the left and right sides of the
machine from the normal operating position.
Note:
To operate the bunker pump, the traction unit
must be equipped with the Rear Remote Hydraulics
Kit, Model 08781 or the Front Remote Hydraulics Kit,
Model 08782.
1
Mounting the Bunker Pump
to the Traction Unit
Parts needed for this procedure:
1 Bunker pump assembly
Procedure
1. Remove any attachment from the machines
adapter.
2. Move the machine into position behind the
attachment adapter.
Note:
Make sure the locking lever
pivoted to the left (unlocked position) as viewed
from the rear of the machine.
Description
Bunker pump assembly
No parts required
(Figure
Qty.
1
–
Qty.
1 Use to reference part numbers
1 Read before operating the machine
1 Declaration of conformity
1. Attachment adapter
3. Raise the machine adapter into the attachment
adapter.
4. Pivot the locking lever to the right to lock the
adapters together.
5. Make sure the engine and the remote hydraulics
kit are OFF.
3) is
6. Plug the hydraulic hoses into the Sand Pro
machine remote hydraulics. Position the hoses
in the hose guide
sharp bends to the hydraulic hoses.
6
Use
Mount the bunker pump to the traction
unit.
Adjust the link assembly.
Use
Figure 3
2. Locking lever
(Figure 4). Avoid kinks and
g008164