2.9.2
SINAUT ST7 configuration software for the PG
The configuration tools operate under Windows 2000 or XP. An installed version of the
STEP 7 software V5.1 SP 2 or higher is also required; for SINAUT connections over
Ethernet, STEP 7 V5.3 SP 2 or higher.
The configuration software includes the following components:
● A module manager that expands the
● A WAN manager that expands the
● The SINAUT ST 7 configuration tool is used for project-wide functions such as SINAUT
● The SINAUT ST7 diagnostics and service tool. In addition to the diagnostic functions
The module manager for SINAUT ST7
The SINAUT module manager expands the catalog of the STEP 7 hardware configuration
tool HW Config. The
all available TIM modules.
You can select the required TIM module from the
rack.
You can then open a properties dialog and assign the required parameters to the module.
This dialog is also available in the
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06
parameter assignment of the TIM modules in
and parameter assignment of the SINAUT WAN networks SINAUT network nodes in
NetPro
.
connection configuration and SINAUT subscriber management.
familiar from STEP 7. Using the service tool, it is, for example, possible to load new
software on a TIM.
SIMATIC 300
Introduction to the SINAUT ST7 system
2.9 The SINAUT ST7 standard software package
HW Config
STEP 7 tool. It handles the display and
HW Config
NetPro
STEP 7 tool. This is responsible for the display
folder was extended by the
SINAUT ST7
NetPro
network configuration tool.
.
SINAUT ST7
folder. This lists
folder and install it in the S7
87