Table of Contents
Advertisement
Table 5-15
Adapter cable for a TIM 4 with integrated DCF77 radio clock
Order no.
Description
6NH7700-0AD15
Adapter cable for connecting a DCF77 radio clock
integrated in a TIM, to adapt the internal connector
to the external BNC connector.
Cable length 1.5 m
Interface adapter cable
The TIM 4R or TIM 4RD does not have an integrated modem but instead has a second serial
port (combined RS-232/485). The port connector is accessible at the same location as the
RJ-12 connector of the integrated modem in the form of an 8-pin RJ-45 plug.
An adapter cable is required to connect the second serial port with an external modem or
other transmission device. At one end of this cable, there is an RJ-45 plug and at the other
end, a 9-pin D-sub miniature male connector to which the normal connecting cable to the
modem/transmission device can be connected.
The adapter cable is supplied with each TIM 4R/4RD module. It can also be ordered as a
spare part under the number listed in the following table.
Table 5-16
TIM 4R / 4RD interface adapter cable
Order no.
Description
6NH7700-0AS05
Adapter cable for connecting the 2nd serial RS-
232/485 port integrated in a TIM 4R / 4RD instead
of an internal modem to convert the internal plug
(RJ-45) to the 9-pin D-sub miniature male
connector required externally.
Cable length 0.5 m
5.4
Options for attachment and settings of the TIM 3 and TIM 4 variants
Introduction
The following paragraphs explain the attachment options for each TIM variant of the TIM 3
and TIM 4 series and the location of the DIL switches with which you can make the hardware
settings for the particular TIM variant. Exceptions are the TIM 3V-IE variants and the
TIM 4R-IE.
In all the figures, the TIM is shown without front panels.
Note
Before you install a TIM module on the S7-300 rail, it is advisable to make all the required
settings for operation on all the DIL switches of the TIM. These switches are more
accessible when the module is not installed. If there is a DCF77 radio clock on the TIM, you
should also plug in the DCF77 adapter cable before installing the TIM.
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06
5.4 Options for attachment and settings of the TIM 3 and TIM 4 variants
Installing and putting a TIM into operation
Illustration
Illustration
177
Advertisement
Table of Contents
