Panasonic TX-42LZ980B Operating Instructions Manual page 25

Indicator / Control panel
When pressing 4, 5, 6 buttons, the control panel guide
≥
appears on the right side of the screen for 3 seconds
to highlight which button has been pressed.
1 2 3
Rear side of the TV
1 Remote control signal receiver (for infrared
communication)
Do not place any objects between the TV remote
≥
control signal receiver and remote control.
2 Ambient sensor
Senses ambient lighting conditions to adjust the
≥
picture when [Auto Brightness] and [Auto White
Balance] (Picture > Ambient Sensor Settings) are
set to [On].
3 Power LED
Red:
Standby
Green:
On
• Depending on the ambient brightness, adjusts
the brightness of LED to easy-to-view levels
automatically.
Orange:
Standby with some functions (recording, etc.)
active or panel maintenance in progress
The LED blinks when an infrared signal is received
≥
from the remote control.
4
5
6
7
4 Input mode selection
≥ Press repeatedly until you reach the desired mode.
Menu
Press and hold for about 3 seconds to display the
≥
menu bar.
OK (when in the menu system)
5 Channel Up / Down
≥ Cursor Up / Down (when in the menu system)
6 Volume Up / Down
Cursor Left / Right (when in the menu system)
≥
7 Mains power On / Off switch
≥ Use to switch the mains power.
To turn Off the apparatus completely, you must pull
≥
the mains plug out of the mains socket.
[ ]: Standby / On
≥
Panel maintenance
Be sure to turn the TV off with the remote control to
perform the panel maintenance. The panel maintenance
automatically starts, and it takes approx. 10 minutes.
During the panel maintenance, LED turns to orange.
≥ During panel maintenance, avoid touching and
exerting any pressure on the screen. (e.g. wiping the
screen, etc.)
≥ For information about panel maintenance, refer to
[eHELP] (Search by Purpose > Watching > For best
picture > Screen Settings).
25
English