Status Calls; Data Calls - Kenwood TK-7185E Instruction Manual

S C
TATUS ALLS
■ M
S
AKING A TATUS
1 Press the
your desired call address.
2 Press the Status/ Stack key (default is the S key), then press the
keys to select your desired status.
• The status number appears on the sub-display.
3 Press the Call key (or PTT switch if "PTT to Initiate Call" has been
programmed) to send the status.
• "CALLING" appears on the display.
4 When the status has been received by the called party, "COMPLETE"
momentarily appears on the display before returning to the previously
selected call address.
■ R
S
ECEIVING A TATUS
1 When a call is received, the
• The icon remains on the display when there is data in the stack.
2 To view the status or message, refer to "Viewing the Stack", on page 12.
D C
ATA ALLS
■ M
D
AKING A ATA
1 Enter control code
2 Press the
• Enter characters using the keypad or by pressing the
pressing the
• To clear a character, press the Clear key. To clear all entered characters, press
and hold the Clear key.
3 Press the
4 Enter the ID number of the unit you want to send the message to.
5 Press the PTT switch, the Call key, or the # key to transmit.
■ R
D
ECEIVING A ATA
1 When a call is received, the
• The icon remains on the display when there is data in the stack.
2 To view the message, refer to "Viewing the Stack", on page 12.
C
ALL
and keys (Call Address Up / Call Address Down) to select
/S D M
HORT ATA
C
ALL
2 to make a SDM (Short Data Message) call.
key, then enter your message.
and keys, press the <B or C> key to set the selected character.
key to end your message.
C
ALL
C
ESSAGE ALL
icon appears on the display and fl ashes.
icon appears on the display and fl ashes.
and
and keys. When
11