Sanyo FWBP706FA Owner's Manual page 47

6. Use [ ] to select "Next", then press [OK].
Network
Language
Streaming Co...
Security
System
7. "Connection success and IP is obtained." will be displayed. Press [OK] to complete the settings.
Note
D
• The Internal wireless LAN supports following specifications.
- Wireless standards: IEEE 802.11 b/g/n
- Frequency: 2.4 GHz
- Security protocol: WEP* / WPA / WPA2
* "WEP" is not recommended to be used due to its "Major security flaws". Change the security protocol on
the wireless router to "WPA" or "WPA2 (recommended)" mode.
Manual
Set up the connection to the wireless router manually by entering the SSID.
In the following cases, select "Manual" to set each setting as necessary.
- When connection test failed with the setting of "Scan".
1. Follow steps 1 to 5 in "Auto" on page 45.
2. Use [ ] to select "Manual", and use [
3. Use [ ] to select the SSID entry field, then press [OK]. The software keyboard will appear.
4. Use [
5. Use [ ] to select "Next", then press [OK].
6. Security mode selection screen will appear. Use [
[OK].
• If you select "None", please go to step 10.
Network
Language
Streaming Co...
Security
System
EN
Setup
WPA-PSK
**********
Previous
Next
Exit
] and [OK] to enter the SSID. After entering the SSID, select "Enter", then press [OK].
Setup
Please select the Security Mode
None
WEP
WPA2-PSK(AES)
WPA/WPA2-PSK(AUTO)
Previous Next
] to select "Next", then press [OK].
] to select the desired security mode, then press
47
continued on next page