Installation
Installation with a downdraft ex-
tractor
Please refer to the "Downdraft extractor
with ProLine elements" operating and
installation instructions for details about
installing the downdraft extractor and
the ProLine elements.
Fitting the ProLine element
Feed the mains connection cable
down through the worktop cut-out.
Starting at the front, position the Pro-
Line element in the worktop cut-out.
Using both hands, press down evenly
on the sides of the ProLine element
until it clicks into position. When do-
ing this make sure that the seal of the
appliance sits flush with the worktop
on all sides. This is important to en-
sure an effective seal all round the
worktop.
Do not use any additional sealant
(e.g. silicone) on the ProLine ele-
ment.
If the seal does not sit flush with the
worktop in the corners, the corner ra-
dius (≤ R4) can be carefully cut to fit
using a jigsaw.
54
Installing several ProLine elements
Push the built-in ProLine element to
the side until the holes in the spacer
bar can be seen.
b
Push the cover strip into the desig-
nated holes in the spacer bar .
Starting at the front, position the next
ProLine element in the worktop cut-
out.
Proceed as described previously.
a