R E A R P A N E - Kenwood CS-2110 Instruction Manual

REAR PANEL
@ C A L Loop
Current Probe calibration loop.
square w a v e is provided.
© A G A T E J a c k
T h e output connector for the A s w e e p gate, a square
w a v e gate signal.
® B G A T E J a c k
T h e output connector for the B s w e e p gate, a square
w a v e gate signal.
© C H 1 O U T J a c k
Channel 1 vertical output signal connector, a c c o u -
pled output connector.
measure the frequency by connecting the frequency
counter.
C O N T R O L S A N D
A 1 0 mA, 1 kHz
T h i s connector is used to
I N D I C A T O R S
Fig. 4
© Z. A X I S INPUT J a c k
External intensity modulation input; T T L compatible.
Positive voltage decreases brightness, negative v o l -
tage increases brightness.
© P O W E R LINE C O N N E C T O R
T h e input connector for the ac power cord.
© F U S E H O L D E R
Contain the line fuse. Verify that the proper fuse is i n -
stalled (1.2A).
© Handle (shown in 10 pages)
Carrying handle with comfortable molded finger grip
also doubles a s tilt stand. Locking detent each 15° a l -
l o w s adjustment of viewing angle.
© Feet
Rear feet support oscilloscope in face-up position and
double a s cord wrap for storing power cord.
1 3