Sharp DV-500D Technical Manual page 90

FLOW CHART NO.6 INFRARED R/C TROUBLESHOOTING
No operation is possible from infrared remote control.
Dose the infrared remote control function?
Yes
Is the supply voltage of 5V fed to pin(3) of remote
control receiver?
Yes
Is"L"pulse sent out from pin(1) of the receiver
when the infrared remote control is activated?
Yes
Check between at pin(1) of receiver thru pin(32) of
IC504.
FLOW CHART NO.7 SYSTEM CONTROL TROUBLESHOOTING(1)
Unit is in standby but won't power up.
Does the P-CON(H) signal at pin(116) of IC504
change from "L" to "H" level?
Yes
Dose the base of Q9005 change from "L" to "H"
level?
Yes
Are the circuits of AUDIO 9V SW turned on?
FLOW CHART NO.8 SYSTEM CONTROL TROUBLESHOOTING(2)
The disc tray cannot be opened and closed.
Is 0.6V fed to pin(95) of IC504?
Yes
Is the signal input from Pins (70), (69) of IC504 to
Pins (2), (4) of IC701?
Yes
Is the loading motor drive voltage output from Pins
(9), (7)of IC701?
Yes
Is the loading motor drive voltage applied to Pins
2, 3 of AG connector?
Yes
Is the voltage applied from AG connector to
loading motor?
Yes
Check engagement of mechanism and gear and
check for damage.
FLOW CHART NO.9 FOCUS TROUBLESHOOTING(1)
Focus failure.
Remove the disc. Dose the optical pickup move up
and down?
Yes
Set the disc. Does the pin(27) of IC303 output the
FE waveform?
No
Replace infrared remote control as required.
No
Check AT 5V and GND lines.
No
Replace receiver.
No
Replace IC504.
No
Check IC504.
No Check lines between the Q9005 and all the way up
thru to IC504.
No
Refer to FLOW CHART No. 7.
No Check lines between at AD connector and TB
connector.
No
Check between IC701 and IC504.
Check AT 8V line.
No
Is 8V voltage applied to Pins (3), (8) of IC701?
No
Check between IC701 and AG connector.
No Check between AG connector and mechanical
relay PWB and between mechanical relay PWB
and loading motor.
No See FLOW CHART NO.14 FOCUS TROUBLE-
SHOOTING(2) Focus failure.
Yes
No Is the input waveform at pins(57),(58),(59) and (60)
of IC303 present?
Is the output waveform at pins(17) and (18) of
IC301 present?
Check the connection of optical pickup cable.
If OK, optical pickup is defective.
11-2
No
Yes
Replace IC701.
Yes
No
No
DV-560H