Sharp DV-500D Technical Manual page 103

DV-560H
12-6. IC501 IX1502GE
FLASH
Symbol Type
DQ /A Input
15 -1
A -A Input
0 12
A -A Input
13 17
DQ -DQ Input/Output input. Various data read memory identifier and status data output Chip nonselection or output
0 7
DQ -DQ Input/Output
8 15
CE# Input
RP# Input
OE# Input
WE# Input
RY/BY# Output
BYTE# Input
Vpp
Vcc
GND
NC
Byte selection address: When the device is in the x8 mode, the low or high order byte is
selected. It is not used in the x16 mode.
(If BYTE# is high, DQ /A
15
Word selection address: Selection of one word of 16k byte block. These addresses are
latched during data wiring operation.
Block selection address: Selection of 1/32 erase block. These addresses are latched
during data writing, erasing and lock block operation.
Low order byte data input/output: Command user interface writing cycle data and command
disable: Float state
High order byte data input/output: The function is the same as that of low order byte data
input/output. Operative only in x16 mode. x8 mode: Float state DQ
Chip enable: Device control logic, input buffer, decoder and sense amp. are activated.
Chip becomes active only when CE# is "Low".
Reset/Power down: If RP# is set to "Low", the control circuit is initialized when power
is turned on. Hence, the RP#pin is set to "Low". When power is turned on or off or in
case of fluctuation it is kept at "Low" so as to protect data from noise. When RP# is in
"Low" state, the device is in deep power down state. 480 ns is required to recover
from the deep power down state. If the RP# pin becomes "Low", the whole chip operation is
interrupted and reset. After recovery the device is set to array read state.
Output enable: When OE# is set to "Low", data is output from the DQ pin. When OE# is
set to "High", the DQ pin is set to float state.
Write enable: Command user interface, data Q register and address Q latch access is
controlled. In "Low" state WE# becomes active. At rise edge the address and data are
fetched.
Ready/busy: The state of internal write state machine is output. In "Low" state it is indicated
that the write state machine is in operation. If the write state machine waits for next operation
instruction, erase is suspended or it is in deep power down state, the RY/BY# pin is in float
state.
Byte enable: When BYTE# is set to "Low", the device is set to the x8 mode. At this time
the DQ -DQ pin becomes float state. Address A
8 15
When BYTE# is "High", the device is set to the x16 mode. The A
Write/erase power supply: 5.0 ± 0.5V is applied during writing/erasing.
Device power supply: 5.0 ± 0.5V
Ground
Nonconnection
Name and function
input circuit does not operate.)
-1
-1
12-10
/A is address.
15 -1
selects high order/low order byte.
input circuit is disabled.
-1