5.5 Installing the USB Port Driver
The USB port is only used for firmware updates. USB driver files are provided as part of upgrade packages
compatible with the RX3i CEP.
With the provided installation files accessible on either a local or network drive, connect the computer's USB
port to the RX3i CEP Carrier's USB port. When requested, direct the installation to the proper location of the
installation files.
The serial port name is COM followed by the next available number from 1 to 256. After the computer assigns
the USB port a COM port number, that computer uses the same COM port number each time it connects to
that RX3i CEP Carrier.
Note:
When connecting the USB cable to the RX3i CEP Carrier, you may receive a notification
about installing a driver that has not passed Windows Logo testing. This notification
should be ignored.
GFK-2883E
March 2018
Chapter 5. Operation
55