Operation 1; Initial Starting Procedure; (1) N O R M A L Sweep Display Operation - Kenwood CS-1044 Instruction Manual

INITIAL S T A R T I N G PROCEDURE
Until you familiarize yourself w i t h the use of all controls,
the following procedure may be used t o standarize the in-
itial setting of controls as a reference point and t o obtain
CS-1044
CS-1025

(1) N O R M A L SWEEP DISPLAY OPERATION

1. Turn the POWER control
supply will be turned on and the pilot lamp will light.
Set these modes as follows;
MODE (Q) : CH1
TRIG MODE @> : AUTO
2. The trace will appear in the center of the CRT display
and can be adjusted by the CH1 • POSITION 0
POSITION @ controls. Next, adjust the INTENSI-
TY (jj) and, if necessary, the FOCUS
observation.
3. Vertical Modes
With vertical MODE (Q)
signal to the CH1 INPUT (5) jack and adjust the
14
OPERATION
(jj) clockwise — the power
and
(0) for ease of
set t o C H 1 , apply an input
trace on the CRT in preparation for waveform observation.
When using the probe(s), refer to probe's instructions and
"PROBE COMPENSATION" listed in APPLICATION of this
manual.
6
Fig.
VOLTS/DIV (2) control for a suitable size display of the
waveform. If the waveform does not appear in the
display, adjust the VOLTS/DIV and • POSITION controls
to bring the waveform into the center portion of the CRT
display. Operation w i t h a signal applied to the CH2 IN-
PUT (D jack and the vertical MODE set t o CH2 is similar
t o the above procedure.
In the ADD mode, the algebraic sum of CH1 + C H 2 is
displayed. If the CH2 INV (Q) switch has been engag-
ed, the algebraic difference of the t w o waveforms,
CH1 — CH2 is displayed. If both channels are set t o the
same VOLTS/DIV, the sum or difference can be read
directly in VOLTS/DIV from the CRT. In the ALT mode,
one sweep displayes the channel 1 signal and the next