Table of Contents
Advertisement
INITIAL STARTING PROCEDURE
Until you familiarize yourself with the use of all controls, the following procedure may
be used to standarize the initial setting of controls as a reference point and to obtain trace
on the C R T in preparation for waveform observation.
W h e n using the probe(s), refer to probe's instructions and " P R O B E C O M P E N S A T I O N "
listed in A P P L I C A T I O N of this manual.
[1] NORMAL SWEEP DISPLAY OPERATION
1 . Push the P O W E R s w i t c h © — the power supply will be turned on and the pilot lamp
will light.
Set these modes a s follows;
V or Y M O D E @ :
T R I G M O D E ® :
2. T h e trace will appear in the center of the C R T display and can be adjusted by the C H 1
^ POSITION © and ^ • P O S I T I O N © controls. Next, adjust the I N T E N S I T Y @ and,
if necessary, the F O C U S (fj) for ease of observation.
3 . Vertical Modes
Apply an input signal to the C H 1 INPUT ® jack and adjust the V O L T S / D I V © control
for a suitable size display of the w a v e f o r m . If the waveform does not appear in the
display, adjust the V O L T S / D I V and y POSITION controls to bring the waveform into
the center portion of the C R T display. Operation with a signal applied to the C H 2 IN-
P U T (J3) jack and the V or Y MODE set to C H 2 is similar to the above procedure.
In the A D D mode, the algebraic sum of CH1 + C H 2 is displayed. If the C H 2 INV © switch
has been engaged, the algebraic difference of the t w o w a v e f o r m s , C H 1 — C H 2 is dis-
played. If both channels are set to the same V O L T S / D I V , the sum or difference can
be read directly in V O L T S / D I V from the C R T . In the A L T mode, one s w e e p displayes
the channel 1 signal and the next s w e e p displays the channel 2 signal in an alternating
sequence.
16
OPERATION
Fig.
C H 1
A U T O
5
Advertisement
Table of Contents
