Rear Panel - Kenwood CS-1044 Instruction Manual

REAR PANEL

@ Z AXIS INPUT
External intensity modulation input; + 5 V.
Positive voltage decreases brightness.
@ > CH1 OUTPUT
AC coupled output connector.
This connector is typically
measurement by connecting the frequency counter.
When the VOLTS/DIV control (6) is at 1 mV, frequen-
cy measurement w i t h the counter may not produce a
correct frequency display due t o noise. In that case,
set VOLTS/DIV t o other range or turn the VARIABLE
control (7) to a position other than CAL.
For stable operation, avoid cascaded connection of
CH1 OUTPUT t o channel 2 input.
Fig. 5
used for frequency
® Fuse Holder, Line Voltage Selector
Contains the line fuse. Verify that the proper fuse is
installed when replacing the line fuse.
100 V, 120 V
2 2 0 V, 2 4 0 V
Value in parentheses (
After pulling the power cord plug from the power
outlet, adjust this selector t o your line voltage.
@ Power Input Connector
Input terminals of power supply. Connect the AC cord
provided.
0.8 A ( 0 . 5 A )
0.5 A (0.3A)
) is for the C S - 1 0 2 5 .
13