Reverse/Invert Image Function; Special Mode Adjustment - Sharp Notevision PG-C20XE Operation Manual

Reverse/Invert Image Function

Projector
ON/OFF
LAMP
POWER
2, 3
TEMP.
KEYSTONE
2, 3
AUTO SYNC
INPUT
1, 4
BACK ENTER MENU
(GUI) On-screen Display

Special Mode Adjustment

Projector
ON/OFF
LAMP
POWER
2, 3
TEMP.
KEYSTONE
2, 4
AUTO SYNC
INPUT
1, 5
BACK ENTER MENU
(GUI) On-screen Display
Remote control This projector is equipped with a reverse/invert image
function which allows you to reverse or invert the pro-
jected image for various applications.
Description of Projected Images
Selected item
Front
Ceiling Front
Rear
Ceiling Rear
1 Press MENU.
2 Press ∂/ƒ to select "PRJ Mode", and then press
3 Press ∂/ƒ to select the desired projection mode,
4 To exit from the GUI, press MENU.
• This function is used for the reversed image and ceiling-
mount setups. See page 19 for these setups.
Remote control Ordinarily, the type of input signal is detected and the
correct resolution mode is automatically selected.
However, since the projector cannot distinguish
640 480 signal resolution on computers or 480P on
DTVs, select an appropriate mode on "Special Modes."
1 Press MENU.
2 Press ∂/ƒ to select "Special Modes", and then
3 Press ∂/ƒ to select the optimal resolution mode.
4 Press ENTER to save the setting.
5 To exit from the GUI, press MENU.
• When inputting DTV 480P signals, select "480P" in step
above.
Projected image
Normal image
Inverted image
Reversed image
Reversed and inverted image
ENTER.
and then press ENTER.
press ENTER.
3
E-36