Transfer Gearbox (Up--Box); Axles; Grease Nipples; Filling Capacities - Toro 007 Maintenance Manual

TKU--- C 01140--- 1 EN 0404

2.5.5. Axles

Classification
Viscosity

2.5.6. Grease nipples

Lithium--based greases with penetration 265/295 (NLGI 2) and dropping point 180 _C
should be used.

2.6. Filling capacities

Engine oil
Engine coolant
Transmission
Transfer gearbox
Axles
Hydraulic oil tank
Fuel tank

2.7. Special notes

If the machine is fitted with optional equipment such as an automatic central lubrication
system, please read the instructions for the additional equipment carefully and adhere to
the service schedule given in the maintenance instructions.

2.7.1. Cooling system

Drain and clean if the engine overheats or solution is dirty.
D
Note! Overheating indicates a fault. Stop the engine and repair the fault before more
serious damage is caused. Make sure that the engine radiator is not covered and that it
is not clogged.
Whenever draining and refilling the cooling system, always recheck the coolant
D
level after the engine reaches its normal operating temperature.
Note! Never open the filler cap when hot.
When checking engine coolant level, stop the engine and allow it and the radiator to cool
down. If an overheated engine must be stopped, allow the radiator to cool down before
checking the coolant level. If there is no time for that, use thick gloves and protective
clothing when opening the radiator's filling cap. Stand to the side, turn your face away, and
open the cap a little. Wait until the pressure is released and coolant stops running out, then
open the cap slowly.
Adding over 19 liters per minute can cause air pockets in the cooling system.
D
Operate with a thermostat in the cooling system all year round.
D
Coolant must be tested every 250 hours to ensure that inhibitor levels remain within
D
the permitted ranges; change the coolant inhibitor filter element if necessary (see
Detroit Diesel Coolant Selections or Engine Operator's Guide).
MAINTENANCE AND LUBRICATION
MIL--L--2105 C or API GL--5 + LS (Limited Slip)
above --25 _C.
--25 _C...+15 _C
SAE 80W/140
SAE 85W/140
29 L (with filters)
55 L
72 L
9 L
2 x 44 L
250 L
310 L
15 (64)