Searching The Tape (Photo Search/Date Search) - Canon ZR Instruction Manual

Searching the Tape (Photo Search/Date Search)

E
OFF VCR
Move quickly through still pictures recorded anywhere on a tape (photo search) or
between different days of recording (date search).
• You can only use this function from the Remote Controller.
1. Press down and slide the POWER switch to VCR.
• Press the SEARCH SELECT button to choose between photo/date search.
• PHOTO SEARCH or DATE SEARCH is shown in the display for a few
seconds.
2. Press the
through the still pictures or between different days of recording.
• Press once to move to the start of the previous/next still picture or day on
the tape.
• For photo search you can press more than once to move to the
corresponding still picture (up to a maximum of 10 times), e.g. press the
button 5 times to move forward 5 still pictures.
• PHOTO-SEARCH/DATE SEARCH appears in the middle of the display
alongside the
photos to search through. The recording mode is also shown (SP/LP).
Notes:
• Press the 3 (stop) side of the multi-switch to end your search.
• If you begin a search very close to the start of a recorded still picture during
photo search, the camera may skip straight past it.
• A date cannot be identified if the total recording time on that day was less than
one minute.
• Date search playback may start just before or after the beginning of the located
section.
• If the data code is not displayed correctly you will not be able to operate the date
search correctly.
• When you have set the REC ZONE for the World Clock, date search looks for
the change in date based on the adjusted time.
56
POWER
and buttons to move backwards or forwards
/" or ^ mark and, for photo search, the number of
or
W T
SEARCH
SELECT
2
WIRELESS CONTROLLER WL-D67