Returning To A Pre-Marked Position - Canon ZR Instruction Manual

Returning to a Pre-Marked Position

OFF VCR POWER
Use the wireless controller to go back to a pre-determined point on a tape
following playback.
1. Press the ZERO SET MEMORY button during playback at a point
you want to return to later.
• ZERO SET MEMORY appears in the display, and the time code is replaced
by a tape counter that is set to zero.
2. When you have finished playback, turn the multi-switch lever to
fast forward or rewind the tape. The tape stops automatically when
it reaches the zero set position.
• ZERO SET MEMORY disappears from the display and the time code
reappears.
Notes:
• Press the ZERO SET MEMORY button once more to cancel the zero set memory
before you forward/rewind the tape.
• The zero set memory may not function correctly where there is a break between
recordings on the tape.
• You can also use zero set memory to mark a position on a tape in record pause
mode. When you then play back the tape, pressing rewind will take you back to
the pre-marked position.
• If you remove the tape while the zero set memory is set, the memory is canceled
and the tape counter reverts to timecode.
ZERO SET
W T
MENU MEMORY
TV DATA SEARCH
SCREEN CODE SELECT
PAUSEa
2
REW PLAYe FF
WIRELESS CONTROLLER WL-D67
STOP3
E
55