Table of Contents
Advertisement
Troubleshooting
they are used for purposes such as opening cans. Do not use metal kitchen
utensils out of their intended uses.
•
Cutlery are made of low quality stainless steel. >>> Corrosion on such items
is inevitable; they should not be washed in dishwashers.
•
Kitchen utensils that are already corroded are washed in dishwasher. >>>
Rust on a corroded item can migrate to other stainless steel surfaces and
cause corrosion on those surfaces as well. Such items should not be washed
in dishwashers.
Detergent remains in detergent dispenser.
•
Detergent dispenser was damp when adding detergent. >>> Make sure that
the detergent dispenser is dried well prior to filling it with detergent.
•
Detergent is added long before the washing process. >>> Pay attention to
add detergent shortly before start-up of the washing.
•
Opening of the detergent dispenser lid is prevented during washing. >>>
Place the dishes in a way that will not prevent the detergent dispenser lid from
opening and the water going into the machine from impellers.
•
Detergent is stored under unsuitable conditions. >>> If you are using powder
detergent, do not store the detergent package in humid places. Keep it in a
closed container if possible. For ease-of-storing, we recommend you to use
tablet detergents.
•
Impeller holes are clogged. >>> Lower and upper impeller holes might be
clogged with food remnants such as lemon pips. Clean the impellers regularly
as illustrated in section "Cleaning and Care".
Decorations and ornaments on kitchen utensils are being erased.
C
Decorated glasses and decorated lustre porcelains are not suitable
for washing in the dishwasher. Manufacturers of some glassware and
porcelain tableware items do not recommend washing such kitchen
utensils in the dishwashers either.
Dishes are scratched.
C
Kitchen utensils that contains or are made of aluminium should not be
washed in dishwasher.
•
Salt leakage exists. >>> Pay attention not to spill salt around the salt filling
hole while adding salt. Spilled salt can cause scratches. Make sure that the
salt reservoir lid is tightly closed after finishing the filling process. Run the
prewash programme to remove the salt that spilled inside the machine. Since
the salt granules that will remain under the lid will dissolve during prewash,
causing the lid loosen, check the lid once again at the end of the programme.
•
Water hardness setting is low or salt level is insufficient >>> Measure the
hardness of the supply water appropriately and check the water hardness
setting.
Dishwasher / User manual
45 / 47 EN
Advertisement
Table of Contents
