Advertisement
SIGNALING SYSTEM
INSPECTION STEPS
If the speedometer will not operate, use the following inspection steps.
*1 Check battery.
↓
OK
Check each coupler and wire connection.
↓
OK
Check multi-function display. (Input voltage)
↓
OK
Check multi-function display. (Output voltage)
↓
OK
Check speed sensor.
*1 marked: Refer to "CHECKING AND CHARGING THE BATTERY" section in the CHAPTER 3.
• Remove the following parts before inspection.
1. Headlight
• Use the following special tools in this inspection.
Pocket tester:
YU-3112-C/90890-03112
→
No good
Recharge or replace.
→
No good
Repair or replace.
→
No good
Replace wire harness.
→
No good
Replace multi-function display.
→
No good
Replace.
7-20
SIGNALING SYSTEM
Advertisement
