CHARGING SYSTEM
INSPECTION STEPS
If the battery is not charged, use the following inspection steps.
*1 Check fuse.
↓
OK
*2 Check battery.
↓
OK
Check each coupler and wire connection.
↓
OK
Check charging voltage.
No good
Check AC magneto. (Charging coil)
↓
OK
Replace rectifier/regulator.
*1 marked: Refer to "CHECKING THE FUSE" section in the CHAPTER 3.
*2 marked: Refer to "CHECKING AND CHARGING THE BATTERY" section in the CHAPTER 3.
• Remove the following parts before inspection.
1. Seat
2. Fuel tank
• Use the following special tools in this inspection.
Pocket tester:
YU-3112-C/90890-03112
No good
No good
No good
OK
↓
No good
CHARGING SYSTEM
→
Replace fuse and check wire harness.
→
Recharge or replace.
→
Repair or replace.
→
Charging system is good.
→
Replace.
7-13