Advertisement
Quick Links
FX-J80J
"Plasmacluster" and "Device of a cluster of grapes" are
trademarks of Sharp Corporation.
* The number in this technology mark indicates an
approximate number of ions supplied into air of
3
1 cm
, which is measured around the center of a
room applicable floor area (at 1.2 m height above
the floor) when the product is placed close to a wall
at the MED mode setting.
FX-J80J_2nd.indd
FX-J80J_2nd.indd
1
1
AIR PURIFIER
OPERATION MANUAL
2022/04/22
2022/04/22
11:04:36
11:04:36
Advertisement
Related Manuals for Sharp FX-J80J
Summary of Contents for Sharp FX-J80J
- Page 1 FX-J80J AIR PURIFIER OPERATION MANUAL “Plasmacluster” and “Device of a cluster of grapes” are trademarks of Sharp Corporation. * The number in this technology mark indicates an approximate number of ions supplied into air of 1 cm , which is measured around the center of a room applicable floor area (at 1.2 m height above...
- Page 2 A unique Combination of Air Treatment Technologies Triple Filteration System + Plasmacluster High Density Plasmacluster 25000 The higher the PCI density is, the more effective PCI has. Triple Filteration System TRAP DUST Pre-filter traps dust larger than approx 240 micron particles. DECREASES ODORS Deodorizing filter absorbs many common household odors.
-
Page 3: Table Of Contents
Thank you for purchasing this SHARP Air Purifier. Please read this manual carefully before using the product. This manual should be kept in a safe place for handy reference. CONTENTS IMPORTANT SAFETY INSTRUCTIONS ....2 CARE AND MAINTENANCE ........4 REPLACEMENT ............ -
Page 4: Important Safety Instructions
• If the power cord is damaged, it must Doing so can cause a short circuit or be replaced by the manufacturer, its electrical shock. service agent, a Sharp authorized • Be cautious when cleaning the main unit. Service Center or similarly qualified Strong corrosive cleansers can damage persons in order to avoid a hazard. - Page 5 CAUTIONS CONCERNING INSTALLATION GUIDELINES OPERATION • Avoid locations where the sensors are exposed to direct wind. • Do not block the air inlet or air outlet. Doing so can cause the main unit to • Do not place the main unit near or on malfunction.
-
Page 6: Care And Maintenance
CARE AND MAINTENANCE Always be sure to remove the power plug from the wall outlet. MAIN UNIT / BACK PANEL ( Pre-Filter ) Wipe with a dry, soft cloth NOTE How to clean hard to remove dirt. Back Panel 1. Add a small amount of neutral detergent to water and soak for about 10 minutes. -
Page 7: Replacement
REPLACEMENT Always be sure to remove the power plug from the wall outlet. HEPA FILTER / DEODORIZING FILTER LIFE OF FILTERS Replacement Filter Model Filter life varies depending on the room environment, Consult your dealer when purchasing a replacement usage conditions, and location of the Main Unit. filter. -
Page 8: Part Names
PART NAMES MAIN UNIT Operation Panel (FRONT) Air Outlet (Front / Back) Cleanliness Monitor Front Display Main Unit Handle (2 Locations: Left and Right) Front Louver Back Panel (Pre-Filter) Air Inlet Deodorizing Filter HEPA Filter Sensor Filter Sensor (Internal) / Odor / Dust(sensitive) Unit* (Plasmacluster Ion Generating Unit) Unit* Holder... - Page 9 OPERATION PANEL Press the button with “ ” to start. FRONT DISPLAY PM2.5 Monitor Power ON/OFF Button Indicates the Dust(sensitive) Sensor detects microscopic dust. AUTO Button, Indicator Light Dust Monitor Indicates the Dust(sensitive) Sensor detects usual dust. CLEAN ION SHOWER Button, Odor Monitor Indicator Light Indicates the Odor Sensor detects odors.
-
Page 10: Preparation
PREPARATION Always be sure to remove the power plug from the wall outlet. FILTER INSTALLATION Remove the Back Panel. Back Panel Remove the plastic bag from the each filter. Deodorizing Filter HEPA Filter Install the filters in the correct order as shown. HEPA Filter Deodorizing Filter Install the Back Panel. -
Page 11: Operation
OPERATION PLASMACLUSTER ION START/STOP SPOT MODE START STOP ♪ ♪ ♪ Use this mode when you want to remove adhering ♪ ♪ ♪ ♪ ♪ odor, germs, and other substances from cloths, sofas and curtains. ♪ AUTO MODE The fan speed is automatically controlled depending Adjust Front Louver manually. - Page 12 ON TIMER CHILD LOCK Select the length of time you want. The operation panel will be locked. The Main Unit automatically starts once the CANCELLATION selected time is passes. (with the Main Unit OFF) ♪ Front Display ♪ ♪ ♪ more 3 sec.
- Page 13 HOW TO CHANGE VARIOUS SETTINGS You can change the functions listed in the table below. Turn the Main Unit power OFF. Select “Setting number”. Reverse Forward ♪ ♪ ♪ more 3 sec. Select “Function number”. Reverse Forward ♪ ♪ ♪ ～...
-
Page 14: Troubleshooting
TROUBLESHOOTING Before calling for service, please review the list below, since the problem may not be the product malfunction. Odor and smoke persists. The Front Display is turned off. • Check the filters. If they appear to be extremely • When Light control is set to “Auto”, the light dirty, clean or replace them. -
Page 15: Specifications
SPECIFICATIONS Model FX-J80J Power supply 220 - 240 V 50 - 60 Hz Fan Speed Adjustment Fan Speed (m /hour) Noise Level (dBA) * Rated Power (W) Standby Power (W) Recommended Room Size (m ~ 62 High density Plasmacluster ion... - Page 16 Sharp. Please retain your sales documentation, as this should be produced to validate a warranty claim.
- Page 17 REGARDING YOUR LOCAL SHARP APPROVED SERVICE CENTRE VISIT OUR WEBSITE AT www.sharp.net.nz CONTACT YOUR SELLING DEALER/RETAILER OR CALL SHARP CUSTOMER SERVICES TELEPHONE: 09 573 0111 FACSIMILE: 09 573 0113 SHARP CORPORATION OF NEW ZEALAND LIMITED FX-J80J_2nd.indd FX-J80J_2nd.indd 2022/04/22 2022/04/22 11:05:43 11:05:43...
- Page 18 MEMO FX-J80J_2nd.indd FX-J80J_2nd.indd 2022/04/22 2022/04/22 11:05:43 11:05:43...
- Page 19 MEMO FX-J80J_2nd.indd FX-J80J_2nd.indd 2022/04/22 2022/04/22 11:05:43 11:05:43...
- Page 20 SHARP CORPORATION OSAKA, JAPAN TINS-B307KKRZ 22E FX-J80J_2nd.indd FX-J80J_2nd.indd 2022/04/22 2022/04/22 11:05:43 11:05:43...