Connection To The Drain; Adjusting The Feet; Electrical Connection - Blomberg LDF30110W User Manual

Installation
A
For your safety, close the
water inlet tap completely
after the washing
programme is over.

Connection to the drain

Water discharge hose can directly be
connected to the drain hole or sink's
drainage. The length of this connection
must be min. 50 cm and max. 100 cm
from the floor. A discharge hose longer
than 4 meters will cause washing
performance to be affected.Attach the
water discharge hose to the drainpipe
without bending it. Tightly fix the water
discharge hose to the drainpipe in
order to prevent any dislocation of the
water discharge hose during operation
of the product.
/40 EN
10
C
Drainpipe must be
connected to the foul water
system and it should not be
connected to any surface
water drain.

Adjusting the feet

If the door of the product cannot
be closed properly or if the product
wobbles when you push it slightly,
then you need to adjust the feet of the
product. Adjust the feet of the product
as illustrated in the relevant section.
A
Diswashers door must be
aligned properly otherwise
hot steam can escape!
Danger of serious burns,
other injury or may damage
furniture.

Electrical connection

Before you insert the plug into the wall
socket make sure that the voltage and
the frequency shown in the rating label
corresponds to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket in a
readily accessible position.
If the supply cord or the mains lead
is damaged please do not replace it
yourself. The supply cord or the mains
lead must be replaced by a Authorised
Service Agent or a similarly qualified
person.
Dishwasher / User manual