Table of Contents
Advertisement
Monitoring and Controlling
A
Moves to the Home screen.
B
Displays the item name.
C
Displays the status of each item.
D
Selects a category from the following.
Status Information, Source, Signal Information, Network Wired, Network
Wireless, Maintenance, Version
Using the Mail Notification Function to Report
Problems
When you set Mail Notification, notification messages are sent to the preset
email addresses when a problem or warning occurs with a projector. This
will enable the operator to be notified of problems with projectors even at
locations away from the projectors.
Network - Notification - Mail Notification
s
Reading error notification mail
p.151
a
• Up to a maximum of three notification destinations (addresses) can
be registered, and notification messages can be sent to all three
destinations at once.
• If a projector develops a critical problem and suddenly stops
working, it may not be able to send a message notifying an operator
of the problem.
• If you set Standby Mode to Communication On, you can control
the projector even if it is in standby mode (when the power is
off).
s Extended - Standby Mode
When the Mail Notification function is set to On and a problem or warning
occurs in the projector, the following email will be sent.
Sender: The email address set in From
Subject: EPSON Projector
Line 1: The projector name where the problem has occurred
Line 2: The IP address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The main message
contents are listed below.
• Clean Air Filter
• Internal error
• Fan related error
• Sensor error
• Lamp cover is open.
• Lamp timer failure
207
p.140
Advertisement
Table of Contents
