Software; Ip Connection; Ip Connection Procedure; Connecting And Setting The Personal Computer - Panasonic AK-HRP1005GJ Operating Instructions Manual

Software

IP connection

IP connection procedure

This section describes how to configure the unit and CCU using the software.
For the system configuration when using IP connections, see the following page.
"System Connection Configuration" (see page 18)
Connection flow
1. Installing the software
Install Easy IP Setup Software and ROP Setup Software supplied with the unit on a personal computer.
Easy IP Setup Software is a tool for setting the IP addresses of the ROP and CCU. ROP Setup Software is a tool for con-
figuring various settings (system settings) of the ROP.
When configuring settings using a personal computer, use the Easy IP Setup Software supplied with the unit.
"Easy IP Setup Software" (see page 122)
"ROP Setup Software" (see page 124)
2. Equipment connections
Connect the unit to the CCU via a switching hub with PoE support (100base-TX) with LAN cables.
Be sure to connect the devices via a switching hub because the personal computer for configuring the IP settings needs
to be connected. Use a switching hub with PoE support because the unit can be powered by PoE.
"IP connection" (see page 19)

3. Connecting and setting the personal computer

Connect the personal computer to the switching hub (100base-TX) using a LAN cable.
Configure the network settings of the personal computer.
Configure the network settings of the personal computer so that it is in the same segment as the unit and CCUs.
"Connecting and setting the personal computer" (see page 120)
4. Device IP address configuration
Configure IP addresses for connected devices using the methods described in "Configuring the settings
using the menus" or "Configuring the settings using Easy IP Setup Software" section.
To configure the settings using the menus, configure the settings by operating the menus of each device. For details on
the menu operation, refer to the operating instructions of the corresponding devices.
"Setting the IP addresses of the devices" (see page 121)
5. Configuring various settings of the ROP
Use ROP Setup Software to configure various settings.
Install the ROP Setup Software supplied with the unit on the personal computer.
Various settings of an ROP connected with an IP connection can be configured.
Create a list of the ROPs in the same system.
Set the ROP system settings.
Set the connection authentication.
6. Start operation
About the IP connection settings
Do not start Easy IP Setup Software and ROP Setup Software during operation. The ROP will be disconnected, which in turn may cause a
problem with operation.
Connecting and setting the personal computer
Establish an IP connection for the personal computer on which Easy IP Setup Software and ROP Setup Software are installed.
Configure the network settings of the personal computer.
Configure the network settings of the personal computer so that the same segment of the devices being connected is used.
The recommended settings are shown below.
IP address
192.168.0.200
Change the IP address if it is already used by another device.
- 120 -
Software