Appendix; Care; Contact With Liquid; Questions And Answers - Verizon V500 Manual

Verizon V500 / USA EN / A31008-M1931-R301-1-6019 / appendix.fm / 30.4.08

Appendix

Care

¤
Wipe the base station and handset with
a damp cloth (do not use solvents) or
an antistatic cloth.
Never use a dry cloth. This can cause
static.

Contact with liquid

If the handset has come into contact with
liquid:
1. Immediately switch the handset off
and remove the batteries.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the hand-
set, with the battery compartment
open and the keypad facing down, in a
dry, warm place for at least 72 hours
(not in a microwave oven, convection
oven, or similar place).
4. Do not switch on the handset again
until it has completely dried.
When it has fully dried, you should be able
to use it again normally.

Questions and answers

If you have any questions about the use of
your telephone, you can contact us at any
time at www.verizon.com
The table below (page 31) contains a list
of common problems and possible solu-
tions.
Troubleshooting
The display is blank.
1. The handset is not switched on.
2. The batteries are empty.
The handset does not respond to a key press.
The keypad lock is activated.
¥
Base Search
!
screen.
1. The handset is outside the range of the base
2. The handset has been de-registered.
3. The base station is not switched on.
Handset does not ring.
The ring tone is switched off.
¥
You cannot hear the ring tone/dialing tone.
Base station's phone cord has been replaced.
¥
¥
3
2
1
The other party cannot hear you.
You have pressed the
set is on hold.
¥
The incoming call number is not displayed
although CID is set.
Caller ID is not enabled.
¥
¥
a
Press and hold the End Call key.
¥
Charge or replace the batteries (page 8).
Press and hold the pound key
Ä
and is flashing on the display
station.
¥
Reduce the distance between handset/
base station.
is flashing on the display screen.
Register
¥
Register the handset (page 24).
¥
Check the base station power cord
(page 8).
Activate the ring tone (page 28).
When purchasing a new cord, make sure
that it has the correct pin connections.
Correct phone jack assignment
4
5
6
i
(INT) key. The hand-
Switch the microphone on again (page 1).
The caller must ask the network provider to
activate Caller ID (CID).
Appendix
#
(page 1).
Please
1 unused
2 unused
3 a
4 b
5 unused
6 unused
31