Installation (Snh-V6430Bnh) - Samsung SNH-V6430BN User Manual

Installation (SNH-V6430BNH)

Precautions
1.
To facilitate monitoring, connect between the PoE adapter [DATA IN] port
and the router.
2.
In a location with a good Wi-Fi signal and no interference, use Wi-Fi
communication.
3. As the front of the lens may become dirty due to rainwater, avoid installing
under the eaves or in a moist space.
4.
Keep it away from direct sunlight, strong light or dust; install it in a place with
clear view.
5.
Do not install it in a place where there are a lot of obstacles.
6. Keep the lens clean at all times.
Wipe off the dust with a soft cloth.
Installing on the wall and ceiling using screws
1. Take out the screws (M3xL20) and anchors (Φ5x25mm).
When installing on a wooden wall
2.
Fix the bracket to the wall using screws, as
shown in the next image. Using a Phillips
screwdriver, fasten screws in 3 screw holes
on the wall on which the camera is to be
installed.
16 · English
When installing on a concrete wall
2.
Fix the bracket on the wall using screws and
anchors. First, mark the wall on which the
camera is to be installed as shown in the
figure.
3.
On the mark, drill a hole to a depth of about
3cm in the wall using a drill bit and drill with a
5mm diameter for concrete. Remove any
debris remaining in the hole after drilling.
J
Use caution when drilling to avoid injury.
4. Insert an anchor in each of the 3 holes for the
screws, then hit the back of the anchor with a
hammer or a rubber mallet until it is
completely inserted.