Yamaha 195S 2021 Owner's/Operator's Manual page 53

AR195 / SX195 / AR190 / SX190
10:27 am
FUEL
100
%
Cruise +4
0.3 Avg MPG
12.3V
1 Cruise assist setting level
TIP:
Once the cruise assist is activated, the set

engine speed can be increased by pushing
the plus side of the switch or decreased by
pushing the minus side. However, the ad-
justment is limited to a maximum of 8 incre-
ments above or below the initial cruise
assist setting. Each time the switch is
pushed, the engine speed will increase or
decrease approximately 100–200 rpm.
While the cruise assist is activated, the en-

gine speed can also be adjusted by operat-
ing the remote control lever.
To deactivate the cruise assist:
Operate the remote control lever to decrease
the engine speed to 3000 rpm or less. Once
"Cruise" and the cruise assist setting level
disappear, the cruise assist is deactivated.
Operating the boat in reverse with more
thrust (reverse RPM control)
Engine speed in reverse is limited to approx-
imately 4500 rpm. If more thrust is required
when the boat is traveling in reverse, use the
reverse RPM control. WARNING! Be pre-
pared to reduce throttle as soon as the
boat moves as desired. Otherwise, the
0
MPH
1
Instrument operation
boat may become unstable, which could
result in loss of control and an accident.
To activate the reverse RPM control:
Depth
(1) Move the remote control lever backward
9
ft
so that the throttle is opened in reverse.
(2) Increase the engine speed to 4500 rpm,
and then push the plus side of the no-
wake mode / cruise assist switch.
1350
TIP:
RPM
Once the reverse RPM control is activated,
pushing the plus side of the no-wake mode /
cruise assist switch will increase the available
engine speed by approximately 500 rpm in 3
stages up to a maximum of 6000 rpm, and
pushing the minus side will decrease the
available engine speed. However, the adjust-
ment is limited to these 3 increments.
To deactivate the reverse RPM control:
Operate the remote control lever to decrease
the engine speed to less than 4500 rpm.
45