Table of Contents
Advertisement
Pre-operation checks
Operating the fire extinguisher
A chemical-type fire extinguisher may not
help when sprayed into the engine compart-
ment through the FIRE-PORT™ because that
type needs to be aimed directly at the base of
the flames to be effective. See below for
FIRE-PORT™ information.
1 FIRE-PORT™
110
A FIRE-PORT™ is mounted below the rear
center seat. Use this port to spray the con-
tents of a fire extinguisher into the engine
compartment if a fire breaks out in the engine
area. WARNING! If there is a fire in the en-
gine compartment, opening the hatch will
add more oxygen to the fire, increasing
the risk of a larger fire or an explosion.
If you see smoke or otherwise suspect a fire,
you can look through the transparent flaps of
the FIRE-PORT™ to look for signs of flames.
If there is a fire, push the nozzle of the fire ex-
tinguisher through the FIRE-PORT™ and fol-
low the manufacturer's instructions to empty
the contents of the fire extinguisher into the
engine compartment.
A "clean agent" type fire extinguisher is rec-
ommended; a chemical-type fire extinguisher
may not be adequate in this application.
Access port cap check
Make sure that the access port cap is secure-
ly installed.
1
To check the access port cap:
(1) Open the rear platform hatch. (See page
85 for information on the rear platform
hatch.)
(2) Make sure that the access port cap is se-
curely installed. If it is removed or is not
locked, securely install it. (See page 149
for information on the access port cap.)
Advertisement
Table of Contents
