Toro Sand Pro 140-0274 Installation Instructions

Drag Mat Kit
Sand Pro
Model No. 140-0274
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Weight kit 100-6442
Front lift frame kit 08712
Drag mat
Chain
Screw (5/16 x 1-1/2 inches)
Locknut (5/16 inch)
Left cradle
Right cradle
Bolt (3/8 x 1-3/8 inches)
Flange nut (3/8 inch)
Washer (3/8 inch)
Shackle
Clevis pin
Hairpin cotter
Important:
For traction unit Models 08703 or 08743, you must install weight kit 100-6442 before
operating this attachment.
Important:
For traction unit Models 08705 or 08745, you must install either weight kit 100-6442 or front
lift frame kit 08712 before you operate this attachment.
Important:
You must install a finish grader on the rear of the machine before the drag mat can
be installed.
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® Traction Unit
Qty.
Not
included
Not
included
1
1
1
1
1
1
4
4
4
1
1
1
Register at www.Toro.com.
Install the weights to the machine (Models 08703, 08705,
08743, or 08745) or the front lift frame (Models 08705 or
08745 only).
Install the chain to the drag mat.
Install the cradles.
Original Instructions (EN) All Rights Reserved *3440-384* A
Printed in the USA
Form No. 3440-384 Rev A
Installation Instructions
Use