Optional modules
40
Dispensing calibration
V:
100 ml
Press the multifunction button
Stop the pump by pressing the
tomatically after 60 seconds.
Measure the required amount in the measuring vessel.
Dispensing calibration
V:
100 ml
Enter the amount measured in the
P
The throughput
is calculated in
Press the "Save" function button.
The measured value is assigned to the pump.
Reattach the hose.
Cleaning and maintenance of the dispensing system
Rinse the dispensing system through with hot water every 2 weeks,
or before shutting the dispenser pumps down for any length of time,
to avoid the system getting clogged up and corroded.
To do this, rinse out the siphons with water.
Put the siphons in a container with warm water (104 - 122 °F / 40 -
50 °C).
Activate the dispenser calibration switch in each pump, until the
dispensing system is rinsed through.
Check the connections, hoses, dispensing sockets and seals for
leaks.
Peak-load negotiation
When the peak-load function is activated, the heating is deactivated
and the program stopped.
Activate the peak-load function.
The following message appears in the display:
1
Hot Wash
Program stop - Peak load function
Program will continue.
Dispensing pump 1
t:
0
s
P:
No
0/1
0/1
.
0/1
button, or the pump will stop au-
Dispensing pump 1
t:
s
P:
200,0 ml min
30
0/1
V:
field.
ml/min
/
by the controls.