Sharp JW-20CM User Manual page 71

Turn "ON" the power of master module
Connect support tools
· Connect a support tool with the JW-20CM
master module and prepare the setting
parameter.
<Usable support tools>
JW-13PG/12PG
JW-50SP
JW-50PG, Z-100LP2S
· For operation of each support tool, see the instruction manual attached. The following describes
an example of JW-13PG's key operation.
Stop PC operation
· Turn to program mode (stop PC operation). Setting of parameters is only available when the PC
is in program mode.
(Operation example of JW-13PG)
Select initial mode
Stop operation of remote I/O
· Setting of the parameter is only available when the operation of the JW-20CM is stopped.
· Write "00 " to parameter address 007777
(H)
(Operation example of JW-13PG)
Display the contents of parameter
address 003777 by hexadecimal.
Reference Function of JW-13PG
• key: Changeover unit of figures
• key: Byte display
To the next page
Stop PC operation
Select parameter setting mode.
（
）
Parameter
setting
[HEX (hexadecimal), byte]
and stop operation of the JW-20CM.
(8)
Screen display of JW-13PG
（ ）
Write
00 .
(H) I PARAM.
>03777
→ →
HEX (hexadecimal) OCT (octal)
Changeover word display
←→
8 33
·
03775 HEX 00
03776 HEX 00
HEX 00
→ →
DCM (decimal) Bit pattern
8