Sharp JW-20CM User Manual page 61

From the previous page
Writing to the EEPROM, start operation
· Write "81 " into parameter address 003777
(H)
EEPROM. Then start the slave module.
· After starting operation, the setting value changes to "01
Setting
value
(H)
0 0 Stop operation
0 1 Start operation
8 0 Writing to the EEPROM, stop operation
8 1 Writing to the EEPROM, start operation
0 8 Initialize setting values of parameter addresses
(Operation example of JW-13PG)
Display the contents of address
003777
(8)
Remarks
· Writing time to EEPROM is approximately 0.7 sec. When any error is found for parameter
settings, lights the error code 9F
· Written contents into the EEPROM are automatically written to the RAM of the slave
module when turning ON the power of the PC. At reading, the PC checks BCC and compares
BCC check code of the parameter memory address (003776
the JW-20RS lights the error code 9E
· After initialized the parameters, the JW-20RS initializes parameter address 000000 to
003776 .
(8)
[HEX (hexadecimal), byte]
and write the set parameter contents into the
(8)
."
(H)
Contents
Screen display of JW-13PG
03775
03776
I PARAM.
>03777
Write 81
(H)
by the indication lamp.
(H)
by the indication lamp.
(H)
8 23
·
HEX 00
HEX 00
HEX 01
). When an error is found,
(8)
8