Sharp JW-20CM User Manual page 137

"Run" the slave station PC
Turn "ON" the power of the master station PC and connect support tools
• Connect a support tool with the JW-20CM and prepare
the setting parameter.
<Usable support tools>
JW-13PG/12PG
JW-50SP
JW-50PG, Z-100LP2S
• For operation of each support tool, see the instruction
manual attached. The following describes an example
of JW-13PG's key operation.
Stop PC operation
• Turn to program mode (stop PC operation). Setting of parameters is only available when the PC
is in program mode.
(Operation example of JW-13PG)
Select initial mode
Stop operation of data link
• Setting of the parameter is only available when the operation of the JW-20CM is stopped.
• Write "00 " to parameter address 007777
(H)
(Operation example of JW-13PG)
Display the contents of parameter
address 007777 by hexadecimal.
Reference Function of JW-13PG
• key: Changeover unit of figures
• key: Byte display
To the next page
Stop PC operation
Select parameter setting mode.
（ ）
Parameter
setting
[HEX (hexadecimal), byte]
and stop operation of the JW-22CM.
(8)
（ ）
Write
00 .
(H)
→
HEX →OCT → DCM
(hexadecimal) (octal)
Changeover word display
←→
9 39
·
Screen display of JW-13PG
07775 HEX 00
07776 HEX 00
I PARAM.
>07777 HEX 00
→Bit pattern
(decimal)
9