Sealey AP1520.V2 Assembly Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
1.1. GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop
‰
practice regulations are adhered to when using this bench.
Locate the bench in a suitable work area.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
WARNING! Use the bench on level and solid ground, preferably concrete.
‰
Keep the bench clean and tidy in accordance with good workshop practice.
9
Keep children and unauthorised persons away from the work area.
9
DO NOT use the bench for any purpose other than for which it is designed.
8
DO NOT undertake work on the bench without the workpiece being
8
adequately secured
DO NOT use the bench outdoors.
8
DO NOT get the bench wet or use in damp or wet locations or areas where
8
there is condensation.
DO NOT clean the bench with any solvents which may damage the surface or the protective coating on the worktop.
8
2. INTRODUCTION
Made from oak with a varnished finish. Features tool well, shelf, tool drawer, front and end vices, four metal bench stops and four wooden
board jacks.
3. SPECIFICATION
Model No: ............................................................ AP1520.V2
Size(W x D x H): ...................................1520 x 620 x 850mm
Vice dimensions (x2): .......... 280mm Wide x 190mm Opening
Worktop (W x D): ............................................1390 x 355mm
4. CONTENTS
© Jack Sealey Limited
1.52M WOODWORKING BENCH
MODEL NO:
Wear protective Wear safety
gloves footwear
Original Language Version
AP1520.V2
Wear protective
clothing
AP1520.V2 Issue 1 23/04/21